WALLPAPER · SEQUENTIAL CUTTING

Know where
every drop starts.

Turn your chosen cut length into a roll-by-roll schedule. See the alignment gaps between cuts and the unused tail on each roll.

Free · no account · all positions in centimetres · calculator arithmetic runs locally

ILLUSTRATION — USE YOUR OWN MEASUREMENTS

01 / YOUR CUTTING INPUTS

One drop length. A visible sequence.

Usable roll length (cm)Use the actual length you plan to cut. The 1,024 cm example is hypothetical.Chosen cut length per drop (cm)Include your top + bottom trim and other chosen allowances. This tool does not add or round the cut length.Required whole dropsUse your measured strip count. The original roll planner can help count wall-width drops.Pattern phase sequenceChoose the sequence yourself from your product instructions. This selector does not identify a wallpaper’s match type.

Pattern repeat (cm)A positive repeat controls start positions. Plain mode sets this to 0.First pattern reference on every roll (cm)Distance from the roll beginning to your first phase-A reference. Zero is valid. The same reference resets on every fresh roll.

Lengths accept up to four decimal places of cm. Half repeats are calculated exactly. Plans are limited to 500 drops and 100 rolls; larger plans show an error instead of a partial schedule.

Updates as you edit

Keep the allowances.

Enter the finished cut length you intend to make, including your chosen trim. Changing a start position does not change that cut length.

Keep the phase.

The next drop retains its A/B phase after moving to another roll. A fresh roll does not restart the wall’s drop sequence.

Check the product.

Your pattern’s matching and hanging instructions decide whether this simplified sequence applies. See the guide →

Know whereevery drop starts.

One drop length. A visible sequence.

02 / Roll-by-roll positions

Keep the allowances.

Keep the phase.

Check the product.

Know where
every drop starts.